Description

Extension Cable, Stepper Motor to Dupont 4 (No Latch).

Approximately 1 meter long
Nema 17 stepper motor 6-pin connector to Dupont 4-pin connector.

The default wiring for this extension cable is listed below. You may need to switch the pins around to match your setup. This is done by carefully lifting the plastic tap that holds the pin in place and gently sliding the pin out.

Controller Side Motor Side
PIN 1 —————–PIN 1
PIN 2 —————– PIN 4
PIN 3 —————– PIN 6
PIN 4 —————– PIN 3

View AllClose

Cable - Stepper Motor to PC2510 | Bondtech

Bondtech

$3.99

Bondtech PC2510 to JST-XH6 Cable PC2510 4-pin connector to JST-XH6 6-pin connector. This cable is by default wired for the Bondtech 40mm geared Nema17 motor. Please make sure that it follows

Cable - Stepper Motor to JST-XH4 | Bondtech

Bondtech

$2.99

Bondtech JST-XH4 Cable JST-XH4 4-pin connector to JST-XH6 6-pin connector. This cable is by default wired for the Bondtech 40mm geared Nema17 motor. Please make sure that it follows the schem

Bondtech Heatsink for Nema 17 Stepper Motor — Add to Cart

Heatsink for Nema17 Stepper Motor - Black

PB Select™

$2.49

PB Select™ Black Heatsink for Nema17 Stepper Motor Heatsink in black anodized aluminum to remove heat from desired component.Equipped with self-adhesive on the back for easy attachment. Includes: