Description
DDX Adapter for Mosquito
To use with Bondtech DDX Direct Drive eXtruder for Creality
This set is necessary to install a Slice Engineering's Mosquito hotend in a DDX Upgrade kit.
Important Notes from Bondtech:
Upgrading the hotend to Copperhead™ or Mosquito™ on a Creality with DDX may require you to replace the thermistor.
When replacing the thermistor an update to the firmware is needed. Remember it is not possible to upgrade the hotend if the printer does not have a bootloader.
More information about the Bondtech DDX:
The 4 Phases of Bondtech DDX for Creality
A Cable Set Required for Phase 4
Depending on the Creality model you may want to upgrade to Copperhead™, you will require an additional Cable Set to implement Phase 4.
- CR-10S > a DDX CR-10S Main Cable Set is required.
- CR-10S Pro > a DDX Thermistor Cable Extension Set is required.
- Ender-5 Pro (with bootloader) > a DDX Ender-5 Pro Main Cable Set is required.
- Ender-5 Plus > a DDX Ender-5 Plus Main Cable is required.
