Menhir Xtreme Lock Print Bed Adhesive

Ensures strong adhesion to a hot print surface. Works with a broad range of of common and exotic filaments. 

Size: 120ml 

Includes: Bed Adhesive (1 bottle)

Note: Does not work with PP (Polypropylene)

Compatibility Guide
PLA (Polylactic Acid)
PETG (Polyethylene Terephthalate Glycol-Modified)
SimuBone
HIPS (High Impact Polystyrene)
ABS (Acrylonitrile Butadiene Styrene)
ASA (Acrylonitrile Styrene Acrylate)
PCTG (Polycyclohexylenedimethylene Terephthalate Glycol)
TPU (Thermoplastic Polyurethane)
PC/ABS (Polycarbonate/Acrylonitrile Butadiene Styrene)
PVA (Polyvinyl Alcohol)
TPE (Thermoplastic Elastomer)
Flexible Filaments (e.g., Flex PLA)
PC (Polycarbonate)
Nylon 6 (Polyamide 6)
Nylon 12 (Polyamide 12)
PPA (Polyphthalamide)
PPE/PS (Polyphenylene Ether/Polystyrene)
PVDF (Polyvinylidene Fluoride)
PPS (Polyphenylene Sulfide)
PSU (Polysulfone)
PES (Polyethersulfone)
PPSU (Polyphenylsulfone)
PEEK (Polyether Ether Ketone)
PEKK (Polyether Ketone Ketone)
PEI (Polyetherimide)
TPI (Thermoplastic Polyimide)
Carbon Fiber Filled Filaments
Glass Fiber Filled Filaments
Stone Filled Filaments
Glitter Filled Filaments

⚠️ Important Warnings ⚠️

1️⃣ Verify that the surface is cold before application. Do not apply when it’s hot.
2️⃣ Avoid multiple applications on the same area with the applicator.
3️⃣ Ensure your first layer is perfect. If it's too close, you risk damaging the surface. With our adhesive, a very low Z adjustment is not necessary.
4️⃣ ABS adheres extremely well with our adhesive. Please apply a thin layer; otherwise, you may have difficulty removing it.

Application Instructions:
Shake the bottle well before use
Ensure print surface is clean and residue-free
Apply a thin layer on the print surface with the included brush (Clean Brush: Rinse the brush with water or isopropyl alcohol)
Allow the adhesive to dry
Start printing

Part Removal for Low Temp Materials:
for printing conditions below 300°C
- Wait until the build plate has cooled before removing the part
- With materials like PLA or PETG, the part often releases on its own after cooling
- If it sticks: Apply a little water or isopropyl alcohol around the base to help with removal. Ensure the first layer is perfectly calibrated. If the first layer is too close, materials like ABS and PETG can cause chips or cracks on glass surfaces, even without adhesive

Part Removal for High Temp Materials:
Printing conditions: Above 300°C
- Remove the part immediately after printing while the build plate and part are still hot.
- Why? High-temperature materials contract very quickly when cooling, which can cause cracks on glass surfaces in less than 60 seconds.
- Caution: Handle the part carefully to minimize stress from cooling.
- Use durable print surfaces designed to withstand high-temperature materials to reduce the risk of cracking.