4010 Extruder Fan for MakerGear M2 - 12 volt 

Includes: Fan (1 pcs)

Voltage: 12 VDC
Size: 40x40x10mm
Location: Extruder or electronics case

Fits: M2 (12 volt version)

This is the smaller of the two fans mounted in front of the extruder and also used inside the electronics case.
Fan has a keyed connector, guarding against incorrect plug-in. All fans should be kept free of dust buildup to prevent failure.

Note: M2 3D printers purchased after November 2015 require the 24 volt version of the 40 mm fan— if you are unsure which fan you need, examine the label on your current fan to verify its voltage.