5010 Extruder Fan for MakerGear M2 - 24 volt

Includes: Fan (1 pcs)

Voltage: 24 VDC
Size: 50x50x10mm
Location: Extruder

Fits: M2 (24 volt version)

Mounted at a 45 degree angle in front of the extruder's 40mm fan, this 50 mm fan provides users with greater control over the cooling rate of extruded filament material.
This fan has a keyed connector, guarding against incorrect plug-in. All fans should be kept free of dust buildup to prevent failure. 

Note: Depending on when you purchased your M2, you may need a 12 volt 50 mm fan. If you are unsure which fan you need, you can examine the label on your current fan to verify its voltage.