DDX v3 Adapter Set for CR-10 v2 & CR-10 v3 | Bondtech

This set is necessary to install a DDX v3 upgrade kit on the models listed below.

• Compatible with DDX v3, now even easier to install
• Fit a Direct Drive eXtruder on the CR-10 v2 and CR-10 v3
• Plastic Parts made of PA12 (Nylon) with the SLS 3D printing process
• Better surface finishing and higher working temperature resistance
• Improved bowden and Z-axis end switch support

CR-10S V2 and CR-10 v3 Compatibility

To use this Adapter Set on the printer models mentioned above, you just need the default DDX v3 configuration: Bondtech DDX V3 Direct Drive eXtruder for Creality.

All DDX hotend and bed leveling sensor adaptors are compatible with this setup. Keep in mind, when it comes to the bed leveling sensor, using a Bondtech adapter will change the position of the probe. A change in the firmware may be required.

To use the DDX v3 on your CR-10 v2 or v3 a hotend upgrade is required.
Available options are:

• Copperhead™
• Mosquito™ - Recommended
• Mosquito™ Magnum

Install the hotend and hotend adapter inside the DDX V3 before applying the DDX Mount Plate

Included:

• 1x 10079-5-T DDX 5015 Fan Shroud
• 1x 10079-65 DDX Mount Plate for CR-10 v2
• 1x 10079-45 DDX Bowden Mount 
  (supplied with a tapered thread to better fit the stock metal threaded push-fit)
• 1x 10079-80 DDX Z-Sensor Plate for CR-10 v2
• 7x M3 Square Nut
• 2x M3x25 Screw
• 2x M3x20 Screw
• 2x M3x8 Screw

Watch the video guides below before ordering