Creator Max 2

  Hotend Unclog Pin Helps clear blockages from the hotend Diameter: 1.5mmLength: 133mm Includes: Unclog pin (1 pcs)

  Flashforge Extruder V Bearing Includes: V bearing (1 pcs) Specifications:ID: 3mmOD: 12mmW: 4mmG: 9.5mm Fits:Adventurer 3Adventurer 4Creator 3Creator 3 ProCreator ProCreator Pro 2Creator MaxCreator Max 2DreamerDreamer NXFinder 2Guider 2Guider...

   Used Item:  Removed from low hour 3D printers. Flashforge Stepper Motor - X/Y Axis (Read fit section below) Good quality Moons stepper motors with low hours.  Includes: Stepper motor (1 pcs)Drive pulley (1...

   Used Item:  Removed from low hour 3D printers. Flashforge Stepper Motor - X/Y Axis (Read fit section below) Good quality Moons stepper motors with low hours.  Includes: Stepper motor (1 pcs)Drive pulley (1...

  Y Axis Carriage Bracket - LEFT SIDE ONLY Includes: Left side bracket (1 pcs) Fits:Creator Max 2Creator Pro 2 Note: This is the left side bracket only and does not include the linear bearings, motor or pulley.

  Y Axis Carriage Bracket - RIGHT SIDE ONLY Includes: Right side Bracket (1 pcs) Fits:Creator Max 2Creator Pro 2 Note: This is the right side bracket only and does not include the linear bearings, motor or pulley.

   Used Item  Removed from low hour 3D printer. May have reside from glued belts. Y Axis Carriage Bracket Set Includes: Left side bracket (1 pcs)Right side Bracket (1 pcs)Linear bearings LM8SUU (4 pcs)Limit switch mount...

   Used Item  Removed from low hour 3D printer Pulley and Bracket Assembly Includes: Brackets (2 Pcs)Pullies (2 Pcs)Linear rod (1 Pcs) Location:Left RearRight Rear Fits:Creator ProCreator pro 2

  Linear Rod and Pulley Bracket Holds Y axis rod and pulley in place. Includes: Bracket (1 pcs) Location: Right rear corner only Fits:Creator ProCreator Pro 2Creator MaxCreator Max 2 Note: Does not fit left front/rear or right...

  Linear Rod and Pulley Bracket Holds Y axis rod in place Includes: Bracket (1 pcs) Location:Left RearLeft FrontRight Front Fits:Creator ProCreator Pro 2Creator MaxCreator Max 2 Note: Does not fit right rear corner. If you need...

   Like New  - Removed from new or lightly used printers.  Z Bracket Set These brackets are located at the top and bottom of the z axis and hold the linear rods and leadscrew in place.  Includes: Top bracket (1...

   Used Item  Removed from low hour 3D printer.  Flashforge Z Limit Switch (Endstop) Cable Includes: Cable (1 pcs) Fits: Creator Pro 2Creator Max 2